GE 15298530 - Manual (Page 15)

15
• While the unit is receiving caller ID
information, you cannot access the Memo
mode.
M
EMORY
F
ULL
When the unit's memory is full, it picks up after
10 rings. After a two-second delay, it emits
three beeps. A 20-second waiting period
follows, allowing the caller to enter your
security/user code.
R
EMOTE
A
CCESS
To enter Remote Access mode during or after
the announcement, press the # button and
then enter the correct security/user code. The
unit emits another tone while it waits for you
to enter one of 10 function commands.
See
Page 16 for commands.
After each function is performed, the unit
emits the same tone. If no command is entered
after 20 seconds, the unit disconnects the line
and returns to the Idle mode.
• The unit allows two attempts at entering
the correct security/user code. If, after the
second try, the security/user code is not
correct, the unit disconnects the line and
returns to the Idle mode.
To end the remote operation, hang up or press
3 on the phone for the Hang Up code.
Remember that when you play your messages
by remote access, the Toll Saver feature resets
the unit to answer on the 5th ring.
DISABLING REMOTE ACCESS
To disable remote access, set your security/
user code to 000. This also disables remote
turn on and the ability to erase messages in
the event the unit's memory becomes full.