Grizzly 14-Piece Angle Die Kit H8213 - Manual (Page 6)

Model H8213 14 Piece Angle Die Grinder Kit -4 -
OPERATIONS
Read the manual before operation.
Become familiar with this tool, its
safety instructions, and its operation
before beginning any work. Serious
personal injury may result if safety
or operational information is not
understood or followed.
Installing Bits
The Model H8213 uses bits and cutters
with a
1 /
4
" and 1 /
8
" diameter shaft. See
the Grizzly catalog or www.grizzly.com
for a complete listing of available bits and
accessories.
DO NOT use bits or cutters with a
cutting diameter larger than 1". The
bit or cutter could break apart under
the stresses of high speed use,
causing serious personal injury.
To install a bit:
1. DISCONNECT THE GRINDER FROM
THE AIR SUPPLY!
2. Use the two included wrenches to loos-
en the collet nut, as shown in Figure
2.
Note: It is not necessary to com-
pletely remove the collet nut from the
shaft unless you are also changing the
collet.
3. Insert at least 1 ⁄
2
" of the bit into the
collet.
4. Hand tighten the collet nut, then use
the collet wrenches to fully tighten.
Verify that the tooling bit is secure and
will not pull out.
Figure 2. Loosening the collet.
Like all tools there is potential danger
when operating this tool. Accidents
are frequently caused by lack of
familiarity or failure to pay attention.
If normal safety precautions are
overlooked or ignored, serious
personal injury may occur.