Grizzly G1199 - Manual (Page 14)

-12- G1199/G1200 Drill Press
To stop the vertical travel of the drill bit at a
desired depth, loosen the scale set knob located
on the feed shaft assembly, rotate the handles to
the desired depth and tighten the scale set knob.
Figure 12.
To hold a stationary depth, loosen the scale set
knob and rotate the feed shaft to its lowest point.
Then, rotate spindle depth to the desired depth
and tighten the scale set knob. This will lock the
spindle at the desired depth.
Figure 12.
scale set knob
Spindle Adjustments Table Adjustments
1. To adjust the table up or down, loosen the col-
umn lock handle and turn the crank handle to
the desired height. Re-tighten the column lock
handle.
Figure 13.
2. To swing the table, loosen the column lock
handle and swing the table to the desired
position. Re-tighten the column lock handle.
For long workpieces, swing the work table
away 180° and use the base as your table.
Figure 13.
3. To rotate the table, loosen the table lock han-
dle, rotate the table to the desired position
and re-tighten the table lock handle.
Figure
14.
Figure 13.
lock handle