Genie 1022 - Manual (Page 19)

PN# 3642036212, 8/09/2007
19
DOOR LIMITS
FOR HELP-1.800.354.3643 OR WWW.GENIECOMPANY.COM
6
The OPEN (UP) and CLOSE (DOWN) door positions
are controlled by making the adjustments on the
panel located on the bottom of the power head. The
adjustments that can be made are:
Close Travel Limit,
Open Travel Limit,
Maximum Closing Force,
Maximum Opening Force, and
Transmitter Programming.
ENGAGE CHAIN TO CARRIAGE
1. Press and hold the "Close Travel Limit" button
until the chain advances and engages carriage
(Fig. 6-2).
SETTING & TESTING OPEN/CLOSE LIMITS
FIG. 6-1 Limit controls.
SET
SET
OPEN
FORCE
CLOSE CODE
LEARN LIMIT MANUAL
Open
Travel Limit
Open
Set Limit
Button
Close
Travel Limit
Close
Set Limit
Button
Down Force
Control
Adjustment
Up Force
Control
Adjustment
Learn
Code
Button
LED
Indicator Light
To
Garage Door
• Severe injury or death can result if the door
closing force is set too high.
• Never increase the door closing force above the
minimum required to move the door.
• Never adjust force to compensate for a sticking
or binding door.
• Once per month perform CONTACT REVERSE
TEST as described on the next page and in
Section 10.
WARNING
Limit Controls location
on power head.
CLOSE TRAVEL LIMIT
1. Press and hold the "Close Travel Limit" button
until the door is fully closed.
2. You can quickly press and release the "Close
Travel Limit" button to move the door in small
increments. You can also use the "Open Travel
Limit" button to move the door slightly in the
UP direction.
3. Door is fully closed when the bottom edge of door
presses firmly onto the ground.
4. Once the door is in the desired position, press and
release the "Down SET Limit" button. The
LED indicator light light will blink green once. This
stores the closed position in memory.
OPEN TRAVEL LIMIT
1. Press and hold the "Open Travel Limit" button
to move the door to its fully opened position. This
starts the opener moving in the UP direction.
2. Hold the "Open Travel Limit" button until the
door is in the fully opened position that you desire,
then release this button.
3. You can quickly press and release the "Open
Travel Limit" button to move the door in small
increments. You can also use the "Close Travel
Limit" button to move the door slightly in the
DOWN direction.
4. Once the door is in the desired position, press
and release the "Open SET Limit" button.
The LED indicator light will blink green twice.
This stores the opened position in memory.
SET
SET
FIG. 6-2 Engage Chain to Carriage.
Carriage
Chain - Master Link (engages to carriage)