GE DCVH680EJBB - Manual (Page 7)

10 REVERSING THE DOOR SWING
IMPORTANT NOTES
• Read the instructions all the way through before starting.
• Handle parts carefully to avoid scratching paint.
• Set screws down by their related parts to avoid using them in
the wrong places.
• Provide a non-scratching work surface for the doors.
• Normal completion time to reverse the door swing is 30-60
minutes.
IMPORTANT: Once you begin, do not move the cabinet until
door-swing reversal is completed.
These instructions are for changing the hinges from the right side
to the left side - if you ever want to switch them back to the right
side, follow these same instructions and reverse all references to
the left and right.
Installation Instructions
7
TOOLS YOU WILL NEED
DOOR PARTS
Connect standard metal elbows and ducts to complete the
exhaust system. Cover back opening with a plate (Kit WE1M454)
available from your local service provider. Place dryer in final
location.
ADDING ELBOW FOR EXHAUST
THROUGH BOTTOM OF CABINET
WARNING - NEVER LEAVE THE BACK
OPENING WITHOUT THE PLATE.
For Questions on Installation, Call: 1-800-626-2003 (US) or
1-800-361-3400 (Canada).
500A436P009 Pub # 31-16228
• Insert the elbow through the rear opening and connect it to
the dryer internal duct.
• Apply duct tape on the joint between the dryer internal duct
and elbow, as shown on page 7.
ADDING COVER PLATE TO REAR OF
CABINET
TO REGISTER YOUR DRYER
CALL TOLL-FREE
1-888-269-1192
Prompt registration confirms your right to protection under the
terms of your warranty.
www.GEAppliances.com (US)
PLATE
(KIT WE1M454)
CAUTION:
Internal duct joints must be secured with tape,
otherwise they may separate and cause a
safety hazard.
Phillips-Head
Cresent Wrench
(Adjustable)
Screwdriver
Putty Knife or Thin-
Blade Screwdriver
Hinge Assembly
Hinge
Cover
Nut (#8) - 2 Washer - 2
Plastic Cover
Large Tapping
Screw (#10) … 6
Tapping
Screw (#8) … 2
Machine
Screw (#8) … 6