Grizzly H2911 - Manual (Page 9)

Always disconnect air from nailer
whenever clearing a jammed nail!
H2911 18 Gauge Brad Nailer -8 -
4. The jammed nail should now be visi-
ble; remove it with needle nose pliers.
5. Install the guide cover and check the
safety yoke mechanism for proper
operation (following the same instruc-
tions as mentioned in the Safety sec-
tion).
Figure 5. Removing guide cover.
Cap Screws
Guide Cover
Clearing Jammed Nails
The most frequent situation with any type
of nailer is a nail jam. A jammed nail must
be cleared before using the nailer again.
The two places where a nail can get
jammed are the magazine and the dis-
charge area.
To clear a jammed nail from the magazine:
1. Disconnect the nailer from the air
supply!
2. Open the magazine cover and pull the
magazine all the way back.
3. Locate and remove the jammed brad
nail with a pair of needle nose pliers.
Close the magazine cover so it latch-
es.
To clear a jammed nail from the discharge
area on the Model H2911:
1. Disconnect the nailer from the air
supply!
Remove all brad nails from
the magazine.
2. Remove the plastic cover from the
nose of the nailer.
3. Loosen the 2 cap screws that secure
the driver guide cover to the driver
guide on the nose assembly. Remove
the driver guide cover. See Figure 5
to identify these parts.
Depth Adjustment
Figure 6. Depth adjustment wheel.
1. Rotate the depth adjustment wheel
(shown in
Figure 6) clockwise to
increase the nail depth.
2. Rotate the finger wheel counter-clock-
wise to decrease the nail depth.