Changing the ir channel – Gefen GTV-HDMI1.3-441N User Manual
Page 12
9
CHANGING THE IR CHANNEL
Setting The IR Channel
Use the following procedure to set the proper IR channel on the Switcher.
1
Press and hold the EQ button for approximately 5 seconds to enter the IR
channel selection mode. The currently selected IR channel will by indicated
by a fl ashing blue LED on the Input Indicators (page 5).
2 Press
the
Select button to cycle through each IR channel.
IMPORTANT: The selected IR channel must be the same as the IR channel
set on the IR Remote (see page 8). Refer to the table below for setting the
IR channel.
3
Once the proper IR channel has been selected, press the EQ button to
confi rm and exit the IR channel selection mode. The currently selected input
source will now be indicated.
IR Channel Table
Input LED
IR Channel
1
0
2
1
3
2
4
3