Garmin STYLUS NX200 - Manual (Page 39)

Problems and Solutions 39
■ If paper is jammed, follow these steps:
1. Gently pull out jammed paper from the output tray or sheet feeder.
2. If paper is stuck inside, turn off the NX200 Series.
3. Lift the scanner, remove the jammed paper and torn pieces, lower the
scanner, and turn the NX200 Series back on.
Print Quality Problems
If you have any problems with the copy or print quality, try these solutions:
■ Make sure the document is placed flat against the document table glass and
the NX200 Series is not tilted or placed on an uneven surface.
■ Load the paper printable side up (usually the whiter, brighter, or glossy side).
■ Make sure your paper isn’t damp or curled.
■ Use a support sheet with special paper or load your paper one sheet at a time.
Remove sheets from the output tray so not too many collect at a time.
■ Make sure the type of paper you loaded matches the paper size and paper type
settings in your printer software (see page 25).
■ For the best print quality, use Epson special paper (see page 6) and genuine
Epson ink cartridges (see page 30).
■ If you notice light or dark bands across your printouts or they are too faint,
you may need to clean the print head (see page 29). This unclogs the nozzles
so they can deliver ink properly. Run a nozzle check as described on page 28
to see if the print head needs cleaning.
■ Clean the print head as described on page 29.
■ If you notice jagged vertical lines, you may need to align the print head. See
your User’s Guide for instructions.
■ The ink cartridges may be low on ink. Check your cartridge status (see
page 30) and replace cartridges, if necessary (see page 31).
■ If a dotted line appears in the image, clean the document table glass with a
soft, dry, lint-free cloth (paper towels are not recommended and may
permanently scratch the surface), or use a small amount of glass cleaner on a
soft cloth, if necessary. Do not spray glass cleaner directly on the glass.