Mechanical locks and monitoring, Software locks through the bios setup utility – Gateway 6400 User Manual

Page 89

Advertising
background image

80

Managing Your System

Mechanical locks and monitoring

The system includes a chassis intrusion switch. When the access cover is
opened, the switch transmits an alarm signal to the system board, where server
management software processes the signal.

Software locks through the BIOS Setup utility

The Security tab in the BIOS (see “About the BIOS Setup utility” on page 67)
provides several security features to prevent unauthorized access to the
system. Once the security measures are enabled, access to the system is
allowed only after you enter the correct password(s). For example, the security
features let you:

Set and enable supervisor and user passwords.

Set Unattended Start mode to prevent keyboard or mouse input.

Set user BIOS setup access level (full, limited, view only, or no access).

Set Password Check for

setup only

or

always

.

Enable Unattended Start mode which, when enabled, allows the host
system to complete the boot process without a password, yet causes the
keyboard and mouse to remain locked until the user password is enabled.

Using passwords

If you set and enable a user password but not a supervisor password, enter
the user password to boot the system with unlimited BIOS Setup access.

If you set and enable both a user and a supervisor password:

Enter either one to boot the server and enable the keyboard and mouse.

Enter the supervisor password for full access the BIOS Setup to change
the system configuration.

Changing passwords

To change or delete an existing user password, restart the system and press
F1 to enter the BIOS Setup utility, then enter the password when the system
asks for it during the POST routine. To change the password, select

Change

User Password

from the

Security

menu, then enter and confirm the new

password.

To change or delete an existing supervisor password, restart the system and
press F1 to enter the BIOS Setup utility, then enter the supervisor password
(not the user password) when the system asks for the password during the

05032.book Page 80 Monday, July 10, 2000 11:43 AM

Advertising