Grizzly G6050 - Manual (Page 7)

G6050 Round Head Framing Nailer Kit -6 -
OPERATION
Loading Nailer
To load your nailer:
1. Disconnect the air supply from the
nailer!
2. Pull the magazine pusher all the way
back until it locks in place.
3. Place a stick of nails into the maga-
zine as shown in
Figure 1 . Make sure
the pointed ends of the nails are fac-
ing down.
3. Slide the stick of nails all the way
down to the nose of the nailer.
4. Pull the magazine pusher all the way
back, release the catch pin, then let it
come forward until it rests against the
nail stick.
Figure 1. Loading the nailer.
Single/Bump Fire Mode
The Model G6050 is equipped with a sin-
gle/bump fire trigger.
To select single or bump fire operation:
1. Disconnect the air supply from the
nailer!
2. Locate the hex nut that secures the
safety yoke mechanism to the trigger
housing. See
Figure 2 .
3. To select Single Fire mode, tighten
the hex nut completely.
4. To select Bump Fire mode, unthread
the hex nut at least two full turns.
Figure 2. Single/bump fire adjustment.
Adjustment
Hex Nut
When replacing nails for your Model
G6050, follow these guidelines:
Diameter: .113" - .162"
Length:
2"-3 1 ⁄
2
"
Capacity: 50 Nails