GE 681131690614 - Manual (Page 7)

7
Dry Ironing
1. Plug the cord into a 120-volt AC outlet.
2. Make sure that the Continuous Steam Rotary Knob is in position “X”.
3. By pressing the Fabric Selector button, select the setting best suited for the fabric
to be ironed.
Steam Ironing
1. Follow the instructions for filling the water reservoir.
2. Stand the iron on its heel rest.
3. Plug the cord into a 120-volt AC outlet.
4. Press the Fabric Selector button to reach the desired fabric setting.
5. Wait a few minutes for the indicator light to go out and come back on again. Set
the Continuous Steam Rotary Knob to the required position, then the steam will
emerge from the vents in the soleplate.
NOTE: It is recommended that the Burst of Steam button only be used when the fabric
setting being used is COTTON or LINEN.
SAFETY FEATURES:
NOTE: the iron will go into AUTO OFF mode if it is left unattended and will read
“STAND BY” until the iron is moved again, or it automatically shuts off.
• Sleep condition: If the iron is left immobile for 30 seconds or in vertical position
for 15 minutes, the LCD background will turn off and will flash “STAND BY” in ½
second intervals. Under this condition, the relay has no output and the buzzer will
continuously beep for 2 seconds, then the iron will enter the sleep condition with
the Sleep Indication Lamp (blue lamp) flashing.
• Abnormal alarm: If the sensor gets short-circuited or open circuited, or senses an
abnormal temperature rise, it will alarm after 8 seconds with intermittent beeps in
3 second intervals. After alarm sounds, the LCD will have no display and the Sleep
Indication lamp will flash blue. The buzzer will continue to beep until the
abnormal situation is eliminated.
CARING FOR YOUR IRON
CLEANING:
• Before cleaning the iron, ensure that it is disconnected from the power supply and
has completely cooled down.
• Deposits and other residues on the soleplate can be removed with a rough cloth
soaked in a vinegar/water solution.
• The plastic casing may be wiped with a damp cloth and then polished with a dry
one.
• Do not use abrasives on the soleplate.
STORAGE:
• Set the Continuous Rotary Knob to position “X”.
• Disconnect the plug from the wall socket.