Grizzly H6146 - Manual (Page 10)

H6146 34° Clipped Head Framing Nailer -8 -
OPERATIONS
Loading
Figure 3. Sliding pusher toward the
catch lever.
When replacing nails in your Model
H6146, follow these guidelines:
Diameter: 7 ⁄
64
"- 1 ⁄
8
"
Length: 2"-3 1 ⁄
2
"
Capacity: 100
Strip Angle: 34°
To load your nailer:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
2. Grip the nailer firmly, pull the maga-
zine pusher back, and engage the
catch lever as shown in
Figure 3.
Figure 4. Loading nails into magazine.
3. Insert a strip of nails, pointed-end
down, into the magazine as shown in
Figure 4.
Operating
If you have not read the safety instruc-
tions in this manual, do not operate
the nailer.
Before you operate your nailer, place five
to six drops of the included oil into the
quick connect fitting where the nailer con-
nects to the air supply.
To operate your nailer:
1. Connect the air supply to the quick
connect fitting.
2. To test for proper nail penetration, hold
the nailer perpendicular to the surface
of a piece of clean scrap wood that is
thick enough for the length of nails you
have loaded.
4. Slide the nails all the way down to the
nose of the nailer.
5. Release the catch lever. The pusher
slides forward until it rests against the
nail stick.
Pusher
Catch Lever