GE 45138 - Manual (Page 6)

6 7
Adding a Signal Repeater
Step 1 - Find an electric outlet
near the Sensor having trouble
communicating with the Control
Center. Make certain the location
is between the Sensor and Control
Center. Plug the Signal Repeater
into the outlet and press the ‘Test’
button on the side of Signal
Repeater. It will send a test signal
out to the Control Center and the
LED indicator on the Signal
Repeater will flash rapidly for
about one second, then go out.
Step 2 - When the Control Center receives the
Signal Repeater’s test signal, it will flash the green
power indicator. This means a confirmation signal
was sent back to the Signal Repeater. Release
all buttons.
Test