Gateway AMI 493 - Manual

Update...
AMI 493 RAID controller firmware
update and drive installation
If you add a new hard drive to an existing array that has an
AMI 493 controller (firmware version B147 or older), the
Power Console Plus software will scan the drive in a
continuous loop.
To remedy this situation, do one of the following:

Use the interim solution to install a new drive, perform
a migration, or create a new array.
- OR -

Update the controller firmware to version B148 or greater.
The firmware update is located on the technical support
page on the www.gatewayatwork.com Web site.
Interim solution:
1 Turn off the server.
2 Install the new hard drive.
3 Turn on the server.
4 During the server startup procedure, press C TRL +H to open
the WebBIOS utility and perform the RAID migration or
create another array for the new drive.
5 When done, exit WebBIOS, then reboot the server.
Important If the firmware is not available, perform the interim solution.
8507247.fm Page 1 Thursday, November 9, 2000 8:02 AM