Controls – Grizzly H8115 User Manual

Page 10

Advertising
background image

Model H8115/H8117 Spray Gun

-10-

1. Fluid Control: Controls the volume of

material that travels through the fluid
tip.

2. Pattern Control: Adjusts the spray

pattern from a round pattern to a wide
fan.

3. Air Flow Control: Controls the fluid

pressure inside the spray gun.

4. Atomizing Cap: Controls the spray

pattern from vertical to horizontal.

5. Trigger: Two stage trigger. Stage

one only releases compressed air for
blowing off the work piece. Stage two
sprays material.

6. Cup: Holds material; includes a vent-

ed cap.

Figure 5. H8117 Controls.

2. Screw the cup onto the top of the

body.

3. Install the barbed hose fitting into the

base of the gun handle and tighten in
place with the lock nut.

4. Secure the air hose to the barbed fit-

ting with a hose clamp, or use a

1

4

"

NPT quick connect fitting (not includ-
ed).

Note: A

1

4

" NPT quick connect set-up

will make operation and maintenance
tasks easier.

5. Attach the spray gun to an air supply

regulated between 45 and 60 PSI.

Note: For the best results, use a hose
dedicated for spray use only. Do not
use a hose that has been used with
an in-line oiler or other possible con-
taminant.

If you need additional help with this assem-
bly, call our Technical Support at: (570)
546-9663.

Controls

Cup

Fluid Control

Pattern Control

Air Flow Control

Atomizing Cap

Trigger

Figure 4. H8115 Controls.

Cup

Fluid Control

Pattern Control

Atomizing Cap

Trigger

Air Flow Control

Advertising
This manual is related to the following products: