Giant TRIPLEX CERAMIC GP7155A User Manual
Page 3
3
Specifications
Model GP7155A, GP7255A
Consult the factory for special requirements that must be met if the pump is to
operate beyond one or more of the limits specified above.
PUMP
PULLEY
MOTOR
PULLEY
RPM GPM 800 PSI 1000 PSI 1300 PSI 1500 PSI 2000 PSI
12.75
9.00
479
45.0
25.7
32.1
41.8
48.2
64.3
12.75
9.75
531
49.9
28.5
35.6
46.3
53.5
71.3
12.75
10.75
585
55.0
31.4
39.3
51.1
58.9
78.6
12.75
11.70
638
60.0
34.3
42.9
55.7
64.3
85.7
12.75
12.75
700
65.8
37.6
47.0
61.1
70.5
94.0
GP7155A, GP7255A PULLEY SELECTION & HORSEPOWER
REQUIREMENTS
PULLEY INFORMATION
Pulley selection and pump speed are based on a 1725
RPM motor and "B" section belts. When selecting
desired GPM, allow for a ±5% tolerance on pumps
output due to variations in pulleys, belts and motors
among manufacturers.
1.
Select GPM required, then select appropriate
motor and pump pulley from the same line.
2.
The desired pressure is achieved by selecting the
correct nozzle size that corresponds with the pump
GPM.
HORSEPOWER INFORMATION
Horsepower ratings shown are the power require-
ments for the pump. Gas engine power outputs must
be approximately twice the pump power require-
ments shown above.
We recommend that a 1.1 service factor be specified
when selecting an electric motor as the power source.
To compute specific pump horsepower requirements,
use the following formula:
(GPH X PSI) / 1450 = HP
................................................................ U.S. ........................ Metric
Volume .................................................... 65.8 GPM .............. 250 LPM
Discharge Pressure ................................. 1500 PSI ................. 100 Bar
Speed ...................................................... 2000 PSI ................. 138 Bar
Inlet Pressure ........................................................................... Up to 700 RPM
Plunger Diameter .................................... 2.17” ....................... 55mm
Plunger Stroke ........................................ 2.05” ....................... 52mm
Crankshaft Diameter ............................... 1.89” ....................... 48mm
Key Width ............................................... 0.55” ....................... 14mm
Crankshaft Mounting ............................................................... Either side
Shaft Rotation .......................................................................... Top of pulley towards manifold
Max.Temperature of Pumped Fluids ...... 140
o
F ..................... 60
o
C
Inlet Ports ................................................................................ (2) 2-1/2" NPT
Discharge Ports ........................................................................ (2) 1-1/4" NPT
Weight ..................................................... 374 lbs. ................... 170 kg
Crankcase Oil Capacity .......................... 1.6 Gal. ................... 6.0 liters
Fluid End Material GP7155A .................................................. Bronze
Fluid End Material GP7255A .................................................. Nickle Plated Spheroidical Cast Iron
Mechanical Effecency @ 700 RPM ........................................ 0.83
Volumetric Effecency @ 700 RPM ......................................... 0.96