1 generator control panel, 4 engine specifications, 5 emissions compliance period – Generac 004702-0 User Manual

Page 9: 1 fuel primer, 2 start/stop switch, 3 7.5 amp fuse, 4 line breakers, Figure 2.1 – typical control panel

Advertising
background image

Generac

®

Power Systems, Inc.

7

Section 2 – Operation

QUIETPACT 55, 65, and 75 Recreational Vehicle Generators

1.6.4 ENGINE SPECIFICATIONS

Type of Engine

QUIETPACT 55/65/75 ................................................GT-760

Cooling Method ........................................................Air-cooled
Rated Horsepower

QUIETPACT 55..............................................27 at 3600 rpm
QUIETPACT 65..............................................27 at 3600 rpm
QUIETPACT 75..............................................27 at 3600 rpm

Displacement

QUIETPACT 55/65/75....................................................760cc

Compression Ratio........................................................8.6 to 1
Cylinder Block ..........................Aluminum w/Cast Iron Sleeve
Type of Governor ..............................Mechanical, Fixed Speed
Engine Governor Speed

QUIETPACT 55 ......................................................2200 rpm
QUIETPACT 65/75..................................................2571 rpm

Air Cleaner ........................Paper Element w/Foam Precleaner
Starter ........................................................12-volt DC Electric
Ignition System ......................Solid-state w/Flywheel Magneto
Recommended Spark Plug

Champion ..................................................................RC12YC
AC....................................................................................R45S
Fram Autolite ......................................................................65

Spark Plug Gap........................................0.030 inch (0.8 mm)
Recommended Min. Battery ............400 Cold Cranking Amps

1.6.5 EMISSIONS COMPLIANCE PERIOD

For nonhandled engines the Emissions Compliance
Period referred to on the Emissions Compliance
Label indicates the number of operating hours for
which the engine has been shown to meet Federal
emission requirements.

• For engines less than 225 cc displacement,

Category C=125 hours, B=250 hours, and A=500
hours.

• For engines of 225 cc or more, Category C=250

hours, B=500 hours, and A=1000 hours.

2.1

GENERATOR CONTROL PANEL

The following features are mounted on the generator
control panel (Figure 2.1):

2.1.1 FUEL PRIMER

Before starting a cold engine (if it has not been start-
ed in more than two weeks), you must press this
switch for approximately ten seconds to bring fuel
from the tank to the fuel pump. This rocker type
switch springs back into its original position when
you release it.

2.1.2 START/STOP SWITCH

To crank and start the engine, hold this switch in the
START position. Release the switch when the engine
starts. To stop an operating engine, press and hold
the switch in the STOP position until the engine shuts
off. The switch center position is the RUN position.

2.1.3 7.5 AMP FUSE

The fuse protects the engine’s DC control circuit
against electrical overload. If the fuse element has
melted open due to overloading, the engine cannot be
cranked. If you must replace the fuse, use only an
identical 7.5 amp replacement fuse.

2.1.4 LINE BREAKERS

Protects generator’s AC output circiut against
overload, i.e., prevents unit from exceeding
wattage/amperage capacity. The circuit breaker rat-
ings are as follows:

NOTE:

If this generator has been reconnected for dual
voltage AC output (120/240 volts), you can install
line breakers having an amperage rating that is
different than that stated above. The replacement
line breakers consist of two separate breakers with
a connecting piece between the breaker handles
(so that both breakers will operate at the same
time). If the unit is reconnected for dual voltage,
it is no longer RVIA or CSA listed.

Figure 2.1 – Typical Control Panel

P R I M E

S T O P

S T A R T

F U E L

F

S E

7 .5 A

0

E0580 REV. B

CONTROL CENTER

C I R

U I T

B R E A K E R

B R

A K E R

C I R

U I T

PRESS PRIME SWITCH FOR 10 SECONDS

BEFORE STARTING. WHEN STARTING, DO NOT PRESS

START BUTTON LONGER THEN 15 SECONDS PER ATTEMPT.

IF GENERATOR DOES NOT START.

REMOVE AND INSPECT FUSE.

(SEE OWNER'S MANUAL TROUBLE SHOOTING GUIDE.)

Model

Circuit Breaker 1

Circuit Breaker 2

240 Volt

QuietPact 55

30A

20A

25A 2P

QuietPact 65

30A

30A

30A 2P

QuietPact 75

35A

35A

35A 2P

Advertising
This manual is related to the following products: