Grizzly H0599 - Manual (Page 9)

H0599 18V Cordless Cutting Tool
-7 -
MAINTENANCE
Maintenance
Your cordless power tool will give you hun-
dreds of hours of operation time before
ever needing service. The electrical com-
ponents of this cordless cutting tool are not
user serviceable. Repair should always be
undertaken by a qualified electrical repair
technician.
Keep the cutting tool free from dirt and
grease. Always store it in a dry place,
preferably in the case that is supplied.
The battery will require periodic recharg-
ing, and eventually replacement after it has
exceeded its recharge life (approximately
800-1000 recharge cycles). You will notice
extended charging times or shortened
operation time as the battery experiences
more cycles. Battery must be recycled or
disposed of properly. Refer to the Grizzly
catalog for replacement batteries.
Disassembly and improper reassem-
bly of this device can result in electri-
cal shock danger. Always have this
device serviced by an qualified elec-
trical repair technician. Serious injury
will result.
Operating Guides and Tips
Avoid overloading the cutting tool
Always use sharpened cutting bits.
Do not apply excessive pressure to
the cutting tool while using. If the
speed drops abnormally, decrease
pressure immediately. If the bit stops
abruptly or becomes blocked,
release the trigger at once.
Ensure the safety of the workplace.
Clear the work area of all parts and
debris that may cause injury by flying
objects. Securely fix the object to be
cut or fastened in a vise or otherwise
clamp to avoid injury. Do not attempt
to hold workpiece by hand.
Inspect the cutting tool before use. Run
the cutting tool before using to
ensure all parts are running smooth-
ly and there are no abnormal sounds
or sparks. If any defect is found,
have unit serviced.
Know your worksite. Only cut as deep as
necessary. Check behind walls for
wires, other electrical hazards, or
plumbing.