Grizzly G9906 - Manual (Page 6)

-4 - G9906 7 1 ⁄
4
" Circular Saw
Before You Start
Cutting Depth and
Adjustment
Setting the Edge Guide
OPERATIONS
The Model G9906 was specifically
designed for cutting wood, plastic
and concrete. Do not modify and/or
use this machine for any other pur-
pose. Modifications or improper use
of this tool will void the warranty. If
you are confused about any aspect
of this machine, DO NOT use it until
you have answered all your ques-
tions. Serious personal injury may
occur.
Dust
Port
Angle
Gauge
Edge Guide
Set Knob
Retractable
Blade Guard
Please take the time to familiarize yourself
with the controls of your new saw. Below
are listed the names of controls and fea-
tures found on the saw. Please refer to
Fig. 1
F IG 1
1. Loosen the silver knob to the left and
below the hand grip.
2. Pull or push the saw base to expose
more or less saw blade.
3. To check the depth of cut, compare
the blade depth to the workpiece
thickness and adjust saw base until
approximately 1 ⁄
4
" of the blade is
exposed past the thickness of the
workpiece.
4. Tighten the lock knob.
Adjust saw base so that approximate-
ly
1 ⁄
4
" of the blade is exposed past the
thickness of the workpiece to help
avoid potential kick-back.
1. Loosen the edge guide set knob
located on the top leading edge of
the saw base.
2. Insert the edge guide in the slot just
below the retaining screw.
3. Slide the edge guide until it is insert-
ed through a slot provided on the left
hand side of the saw base.
4. Determine the width of cut needed
for your project and slide the edge
guide using the scale provided.
5. Tighten the edge guide set knob.
Always double check the distance
between the tip of the blade to the
inside edge of the edge guide. Blade
thicknesses can very, causing the
scale on the edge guide to read inac-
curately.