Grizzly G5792 - Manual (Page 6)

Model g5791/g5792 17-piece 1 ⁄
2
" impact Wrench and ratchet Kit -5 -
daily maintenance
your impact wrench and ratchet Must
have 2-6 drops of oil directly dropped
into the air fitting before each use. in
addition, we recommend using an in-line
filter, lubricator, and regulator, as shown in
figure 2 or the included in-line lubricator.
if an in-line lubricator is not used, add 2-3
drops of oil into the tool air inlet every 2
hours of continued use.
these procedures should be done
after each use:
• Before putting the impact wrench or
ratchet away, put 2-6 drops of oil into
the air supply fitting and momentarily
operate the tool to distribute the oil
inside.
•
Wipe the tool exterior and sockets with
a slightly oiled cloth. your goal is to
leave a light film of oil on the tools to
prevent rust.
figure 3. impact wrench control locations.
torque setting
rotation Button
impact Wrench
your new 1 ⁄
2
" drive impact wrench ( figure
3) generates up to 260 ft/lbs. of torque.
only use thick-walled impact sockets
with this air tool. the common thin-walled
chrome sockets may explode if used as
impact sockets, causing serious injury.
At the end of the handle you can adjust the
torque setting by pushing the knob in and
turning the knob to 1, 2, 3, or 4; 1 is the
lowest torque setting.
to change the impact rotation, push the
slide button toward the front of the gun
for clockwise rotation and to the rear for
counterclockwise rotation.
ratchet
your new ratchet ( figure 4) generates up
to 50 ft/lbs. of torque and delivers up to
160 rpM.
to change the rotation, adjust the forward/
reverse dial, as shown in
figure 4.
figure 4. ratchet locations.
Forward/reverse dial