Grizzly Magnetic On/Off G8992 - Manual

For questions or help with this product contact Tech Support at (570) 546-9663 or [email protected]
MODEL G8992
110V MAGNETIC ON/OFF
SWITCH
INSTRUCTIONS
Copyright © ApriL, 2011 By grizzLy industriAL, inC.
WARNING: NO pORTION OF THIS INSTRUCTION SHEET MAy bE REpRODUCED IN ANy SHApE
OR FORM WITHOUT THE WRITTEN AppROVAL OF GRIzzLy INDUSTRIAL, INC.
#ts13925 printed in ChinA
Figure 1. g8992 Magnetic on/oFF switch.
Introduction
the Model g8992 features a recessed magnetic
on ( | ) button. the switch assembly is designed
to snap into a 1
1 ⁄
8
" x 1 7 ⁄
8
" rectangular hole.
Specifications
rated Voltage .............................................. 110V
rated Current ..................................................6A
To reduce risk of serious burns, electrocu-
tion or death when installing this switch:
• Only use this switch to replace an existing
machine switch that has the same physi-
cal configuration and equivalent electrical
specifications/ratings.
• Installation must only be performed by an
electrician or qualified service personnel,
and all applicable electrical codes must
be adhered to.
• Turn off and completely disconnect all
power sources to the machine before
installing the switch.
• Do not use this switch in wet or damp
locations, or near explosive fumes or
flammable liquids. It is not sealed or rated
for these environments.
• Make sure there is a verified machine
ground on the circuit this switch is
installed.