Cleaning and oiling the banks ram-air filter – Banks Power Ford Trucks: (Gas ’87 - 97 7.5L EFI) Power Systems- Stinger system '87-96 SC, EC & CC (For Use w_ 460 EFI Engine) User Manual

Page 6

Advertising
background image

6

cLeaning and oiLing tHe banks raM-air fiLter

NotificatioN
the Banks Ram-air filter comes pre-oiled and no

oiling is necessary for initial installation.

Use Banks Ram-air filter cleaning system (part

#90094), available from Gale Banks Engineering

to service the air filter. follow the instructions

included with the cleaning system to clean and

re-oil your Banks Ram-air filter.

PRE-cLEaNiNG

tap the element to

dislodge any large embedded

dirt, then gently brush with

a soft bristle brush. NOTE: If

complete cleaning is not

practical at this time, reoil the

element and reinstall in your

vehicle.

SPRay-oN cLEaNiNG

spray banks air-filter

cleaner liberally onto

the entire element

and let soak for 10

minutes.

PaN cLEaNiNG

Large air-filter elements

can be rolled or soaked

in a shallow pan of banks

air-filter cleaner. remove

immediately and let soak for

approximately 10 minutes.

cLEaNiNG hiNtS

use only banks air-filter cleaner.

no

gasoline cleaning,

no

steam cleaning,

no

caustic

cleaning solutions,

no

strong detergents,

no

high-

pressure car wash,

no

parts cleaning solvents.

any of these

no

s can cause harm to the cotton

filter media plus

sHrink

and

Harden

the rubber

end caps.

RiNSE off

rinse off the element

with low-pressure water.

tap water is okay. always

flush from the clean side

to dirty side. this removes

the dirt and does not drive it in

to the filter.

dRyiNG hiNtS

always dry naturally. after rinsing, shake off

all excess water and let the element dry naturally.

do not use coMpressed air – do not use open

fLaMe – do not use Heat dryers!

excess Heat WiLL sHrink tHe cotton

fiLter Media. coMpressed air

WiLL bLoW HoLes in tHe

eLeMent.

a E R o S o L

oiLiNG

after cleaning air filter

always reoil before

using. spray banks ram-

air filter oil down into each

p l e a t

with one pass per pleat. Wait 10 minutes and

re-oil any white spots still showing.

oiLiNG hiNtS

never use a banks ram-air filter without

oil (the filter will not stop the dirt without the oil).

use only banks ram-air filter oil. banks air-filter oil

is a compound of mineral and animal oil blended

with special polymers to form a very efficient

tack barrier. red dye is added to show just where

you have applied the oil. eventually the red color

will fade but the oil will remain and filter the air.

neVer use

automatic transmission fluid.

neVer

use

Motor oil.

neVer use

diesel fuel.

neVer use

Wd40, Lps,

or other light-weight oils.

REiNStaLL

reinstall your banks ram-air filter element

with proper care. Make sure the element seats

properly in the filter case. install the cover making

sure it’s in the right position. tighten all the nuts,

bolts, screws or clips to factory specifications.

do Not diScaRd

affix the “do not discard” sticker to the

filter case (included with every banks replacement

element). Make sure you put the sticker in a highly

visible place to alert your mechanic not to discard.

PERfoRmaNcE hiNtS

service every 50-100,000 miles on street-

driven applications. service more often in offroad

or heavy-dust conditions. if an air-filter restriction

gauge is installed, then change the element when

the air-filter restriction reaches 18”/H

2

o.

caUtioN! extremely fine dust from agriculture

or offroad use will pull the oil from the element.

frequent reoiling of the element’s clean side might

be required. completely service when practicable.

for extra protection use an air-filter sealing grease

on rubber ends of the element. service only with

banks air-filter cleaner and banks air-filter oil.

6.

7.

8.

9.

10.

1.

2.

3.

4.

5.

p.n. 96346 V.2.0

Advertising