GE Spacemaker WSM2400L - Manual (Page 23)

PROBLEM POSSIBLE CAUSE AND REMEDY
. Leaving clothes dryer after tumbling stops. after dryer stops
PERMANENT PRESS tumbling, remove and place on hangers.
AND “NO-IRON”
ITEMS
many items in dryer. Dry only one load at a time. Do combine loads.
. Too few items in dryer. If drying only one article, add two or more articles,
even if dry, to insure proper tumbling.
Improper loads. Avoid laundering heavy items, such as work
clothes, with lighter permanent press items such as shirts or blouses. Also do not wash
or dry permanent press items with regular laundry.
Too many items in washer. Items must have to move freely. Permanent press
loads always be than regular loads.. more than
●
Use of incorrect wash and dry cycles, Use permanent press wash
provides a cool-down rinse to use automatic dry
●
Incorrect water level. Use large level for medium medium for
●
or water with plenty of
detergent.
. Accumulation of lime due to use of carbonate detergents. If a non-phosphate
detergent must be used, avoid the use of a detergent.
Failure to use softener. Proper use of fabric softener will
To remove
●
on automatic dry setting with small load.
. and dry on automatic dry setting.
. If unsuccessful, on high heat for and hang immediately.
●
Iron carefully,
. Send cleaners far pressing.
●
Some may remain which cannot be removed?
If you good laundry and permanent press come the
may be good quality. Also, in permanent press blends, -on portion
can eventually wear away leaving synthetic. Since resin
imparts memory, a loss or decrease of permanent performance will result.
23