GE 164D3333P159 - Manual (Page 24)

Adjust the oven thermostat—Easy to do yourself!
24
Operating Instructions
Installation Instructions
Safety Information
Tr
oubleshooting T
ips
Customer Service
You may find that your new oven cooks differently than the one it replaced.
Use your new oven for a few weeks to become more familiar with it. If you
still think your new oven is too hot or too cold, you can adjust the thermostat
yourself.
Do not use thermometers, such as those found in grocery stores, to check the temperature setting of
your oven. These thermometers may vary 20–40 degrees.
NOTE: This adjustment will not affect the broiling or the self-cleaning temperatures (on some
models). The adjustment will be retained in memory after a power failure.
Put the knob in the OFF position.
Pull the knob off by pulling straight out.
Press and hold the HOTTER or COOLER button
for 5 seconds to make the oven 20°F. hotter or
20°F. cooler.
Replace the knob.
When you are adjusting the thermostat, the following
lights will flash indicating where the thermostat will be
set when you release the adjustment button:
■ OVEN ON: Indicates the thermostat will be set at the factory
setting.
■ PREHEATED: Indicates the thermostat will be set 20°F. hotter.
■ CLEAN: Indicates the thermostat will be set 20°F. cooler.
4
3
2
1
(appearance may vary)
For Self-Cleaning Models with Pads and an Oven Temperature Knob
Put the Oven Temperature knob in the OFF position.
Press and hold the HOUR +/– pads for 5 seconds
until the display changes.
Before display changes back, press the HOUR +/–
pads to increase or decrease the temperature in
5 degree increments.
The oven temperature can be increased up to 35°F.
hotter or can be decreased down to 35°F. cooler.
If the oven adjustment is set cooler than the factory
setting a minus sign (–) and the offset temperature will
appear in the display.
Wait several seconds for the control to automatically
set and return to its previous setting. 4
3
2
1
For Self-Cleaning Models with Only an Oven Temperature Knob