GE 45130 - Manual (Page 9)

8 9
Learn button on the Control Center. The unit will
beep once.
Step 2 -
While holding the Learn button, press and
hold the Zone button to be erased. After five
seconds the Control Center will sound two beeps
and the Zone LED indicator will flash twice.
Step 3 - Release all buttons. The Zone has
been erased.
Note: The Zone/Garage Door Sensor cannot be erased if:
- The Zone has been triggered for an Alert or alarm. The
Sensor/Zone must be reset.
- There is loss of signal from the Sensor to the Control
Center (such as low battery, or Sensor is out of range).
- The system is armed.
The Control Center will sound three beeps to indicate it could
not erase the Zone.
Testing a Sensor or your system
Once all the Sensors have been assigned to Zones
in the Control Center you can now test your system.
Ensure the Control Center can receive the signal
from the intended location of the Sensor before
permanently mounting a Sensor.
Step 1 - To place Control Center in Test mode
unplug AC adapter and remove batteries.
Step  - Press and hold the ‘Mute’ button and plug
the AC adapter back into the Control Center. When
all the LED indicators turn on, release the Mute
button. The Control Center is now in Test Mode and
any Sensor can now be tested in any Zone.
Step  - Set the Notification Mode to switch ‘Alert’
position and begin activating Sensors one at a time.
1 2 3 4
Arm
Zone
Armed Power 1 2 3 4
Alert
Chime
Off
Mute
Learn
Input DC 12V
- +
Add a Sensor
Step 1
Press and hold
the Learn button
for three seconds
Step 3
Release the
Zone button
Step 4
Activate the Garage
Door Sensor
Step 2
Select the Zone number