Grizzly 2 1/4 Gallon Paint Tank H6330 - Manual (Page 10)

Model h6330 2 1 ⁄
4
gallon paint tank -8 -
read the manual before operation.
become familiar with this tool, its
safety instructions, and its operation
before beginning any work. serious
personal injury may result if safety
or operational information is not
understood or followed.
like all tools there is potential danger
when operating this tool. accidents
are frequently caused by lack of
familiarity or failure to pay attention.
if normal safety precautions are
overlooked or ignored, serious
personal injury may occur.
3. place the lid assembly on the tank and
evenly hand tighten the lid clamp wing
screws.
4. Adjust the regulator at your air com-
pressor to 50 psi.
5. Fully turn the regulator t-handle coun-
terclockwise to shut the tank regulator
OFF.
to use your paint tank:
1. thoroughly mix and strain your paint
to remove undissolved particles that
could block the flow of material to the
gun.
2. pour paint into the tank; or set a one
gallon can of paint in the tank, making
sure the lid's fluid tube is seated in the
can.
tank setup
6. Connect the paint tank to the air com-
pressor.
7. Adjust the paint tank to 25 psi on the
tank pressure gauge. normal operating
pressure is 25-30 psi. using trial and
error, adjust the paint tank as neces-
sary between this range for optimum
results.
figure 4 . regulator t-handle.
regulator
t-handle