Graco Inc. 233670 - Manual (Page 27)

308813 27
Accessories
Use Only Genuine Graco Parts and Accessories
GUN MANIFOLDS
Order separately; not included with gun
(See page 20 for Parts list)
Part No. 241161, Series A
North America Manifold
Part No. 241162, Series A
International Manifold
Part No. 244930, Series A
High Flow Ambient or Temperature Conditioned Man-
ifold for streaming or spraying
Grounding Clamp and Wire 222011
12 ga, 25 ft (7.6 m) wire
High Pressure Ball Valves, Viton
r Seals
5000 psi (34 MPa, 345 bar) Maximum Working
Pressure
Can be used as fluid drain valve.
210657 1/2 npt(m)
210658 3/8 npt(m)
210659 3/8 x 1/4 npt(m)
Bleed-type Master Air Valve
300 psi (2.1 MPa, 21 bar) Maximum Working Pressure
Relieves air trapped in the air line between the pump
air inlet and this valve when closed.
107141 3/4 npt(m x f) inlet & outlet
107142 1/2 npt(m x f) inlet & outlet
In-line Fluid Filter 210500
5000 psi (35 MPa, 350 bar) Maximum Working Pressure
100 mesh. Fits onto the gun’s fluid connector. 1/4–18
npsm. Includes the parts shown below.
168517
Filter
164075
210501
205264
Needle/Diffuser Options
Needles must be used only with the specified seat to
guarantee proper seating and life.
D Standard viscosity/standard flow
– Fluid Needle 239807, 3/16 in. carbide ball
– Seat 239890 or 233671
D Acid catalyzed materials/very low viscosity
materials
– Fluid Needle 241468, 3/16 in. plastic ball
– Seat 239890
Brush 101892
For cleaning the gun.
Tube Fittings for Air or Water
250 psi (1.7 MPa, 17 bar) Maximum Working Pressure
160
_ F (71_ C) temperature rating
104172 1/8 npt(m) x 1/4 O.D. tube
597151 1/8 npt(m) x 1/4 O.D. tube,
90
_ elbow (swivel)
Temperature Sensor and Cable
For temperature conditioned manifold
198457 RTD Sensor, 100 ohm, 1/8 npt(m)
with 3 pin Picofast connector
198458 RTD cable 6 ft. (1.83 m) Flex cable
to St. Clair connector