Grizzly HYDRAULIC/ELECTRIC LOG SPLITTER H8170 - Manual (Page 10)

-8-
H8170/H8171 Hydraulic/Electric Log Splitter
figure 3. typical type 5-15 plug and receptacle.
Grounding Prong
Neutral Hot
5-15 PLUG
GROUNDED
5-15 RECEPTACLE
Serious personal injury could occur if you
connect the machine to the power source
before you have completed the set up pro-
cess. DO NOT connect the machine to the
power source until instructed to do so.
110v Operation
Amperage Draw
the Model h8170/h8171 motor draws the follow-
ing amps under maximum load:
Motor draw ............................................ 13 Amps
Circuit Recommendations
We recommend connecting your machine to a
dedicated and grounded circuit that is rated for
the amperage given below. never replace a circuit
breaker on an existing circuit with one of higher
amperage without consulting a qualified electri-
cian to ensure compliance with wiring codes.
If
you are unsure about the wiring codes in your
area or you plan to connect your machine to a
shared circuit, consult a qualified electrician.
110V Circuit ...........................................20 Amps
Plug/Receptacle Type
included plug type ........................... neMA 5-15
SHOCK HAZARD!
Two-prong outlets do not meet the grounding
requirements for this machine. Do not modify
or use an adapter on the plug provided—if
it will not fit the outlet, have a qualified
electrician install the proper outlet with a
verified ground.
Extension Cords
Follow these instructions when using an exten-
sion cord with your log splitter:
• use at least a 12 gauge cord that does not
exceed 50 feet in length!
• the cord must have a ground wire and plug
pin; always keep the cord and plug dry.
• A qualified electrician Must size cords over
50 feet long to prevent motor damage.
Electrocution or fire could
result if this machine is
not grounded correctly or
if your electrical configu-
ration does not comply
with local and state codes.
Ensure compliance by
checking with a qualified
electrician!
SECTION 2: CIRCUIT REQUIREMENTS