Grizzly G6772 - Manual (Page 10)

G6044/G6772 16 Gauge Stapler Kit -9 -
Cleaning Stapler
Use a good solvent to clean the nose
assembly of the stapler. Always be sure
that the stapler is dry before using it again.
Do not allow dust, chips, sand, etc. into the
air connectors or into the body of the sta-
pler; this may result in leaks and damage
to the stapler and the air couplings.
Never use gasoline or other flamma-
ble liquids to clean this tool. Vapors
in the tool may ignite, causing the
tool to explode. Ignoring this warning
may lead to serious personal injury or
even death!
Always disconnect air from stapler
whenever servicing! During mainte-
nance, a stapler connected to air
may fire accidentally, causing seri-
ous personal injury!
Oiling Stapler
The Model G6044/G6772 is considered an
oil-less model. This means it features a
teflon piston assembly that does not
require oil to operate. However, periodic
applications of oil will extend the useful life
of the piston assembly.
Special oil has been included with you new
Grizzly stapler. Periodically place one drop
of oil in the stapler air inlet (as shown in
Figure 6 ). After oiling, wipe off any excess
oil near the stapler exhaust to avoid dust
build-up. When the oil that was included
with the stapler has been completely used,
replace with Grizzly Model G2820
Pneumatic Tool Oil.
Another option to manual oiling would be
to install a lubricator in your air compressor
line. If your air compressor line already has
a lubricator, then regular lubrication of your
stapler will not be necessary. Just make
sure there is always oil in the lubricator.
As mentioned before, the best option is to
install a filter/lubricator/regulator unit such
as the Grizzly Model H2333 in your air line.
Figure 6. Lubricating stapler via air inlet.
NOTICE
Too much oil in the stapler will ruin
the O-rings!