GE RM24941 - Manual (Page 7)

Code Search (continued)
Note: If your device responds and you accidentally overshoot that code by pressing the
ON•OFF key again, press the CH- key or DOWN ARROW key to backtrack through the
code library. You can change the direction to forward once again by pressing the
ON•OFF
, CH+, LCD UP ARROW, or PLAY keys.
9. Once the device to be controlled responds to the commands, press and release the LCD
OK key to install the code. The touchscreen returns to the Main Setup Screen. The Code
Search entry is now complete.
10. Press CLEAR on the Main Setup Screen to exit Setup Mode.
Code Autosearch
Your RM24941 has the ability to automatically scroll through the entire code
library by using the Autosearch feature.
1. Manually turn on the device to be controlled (TV, VCR, DVD, etc.).
2. Press and hold the SETUP key on the rubber keypad until the LED
indicator light remains on and the touchscreen shows the Main Setup
Screen. This process takes approximately 2-3 seconds.
3. Release the SETUP key.
4. Press and release the LCD CODE key. The LED indicator light blinks
once to indicate acceptance of the keypress.
5. The touchscreen now shows the Device Setup Screen. Press and release
the device key on the rubber keypad for the device whose code you want
to enter (TV, VCR, SAT/CBL, etc.). The LED indicator light blinks once to
indicate acceptance of the keypress.
6. For AUX1 or AUX2, press and release the AUX device key. Select the
desired device key to be programmed under AUX (TV, VCR, SAT/CBL,
etc.).
7. The LCD touchscreen shows the Code Setup Screen. Press and release the
LCD SEARCH key.
8. The LCD touchscreen shows the Search Setup Screen. Press the ON•OFF
key on the rubber keypad just once. If you do not press any other keys,
the Autosearch feature automatically starts in six seconds.
9. The Autosearch sends the next code in the list every three seconds.
Note: The Autosearch can take a significant amount of time, since there
are many codes in the list.
10. To speed up the Autosearch, you can manually override the process and
temporarily speed it up by pressing the normal search keys (CH+, CH-,
ON•OFF
, PLAY, LCD UP, and LCD DOWN keys) in both forward and
reverse directions.
11. If your device responds to the command, and the RM24941 sends the next
code before you have a chance to press the LCD OK key, you can backtrack
through the code library by pressing CH- or the DOWN ARROW. You can
change the direction to forward once again by pressing the ON/OFF, CH+,
LCD UP ARROW, or PLAY keys.
12. Once the device to be controlled responds to the commands, press and release the
LCD OK key to install the code.
13. The touchscreen returns to the Main Setup Screen. The Code Search entry
is now complete.
14. Press CLEAR on the Main Setup Screen to exit Setup Mode.
5
24941manual 8/13/03 8/19/03 8:42 AM Page 7