Grizzly H8088 - Manual

Model H8088
2-Stage
Transmission Jack
This jack is designed to assist in transmis-
sion removal only. Failure to follow these
instructions when using the transmission
jack could result in serious personal injury
or death:
1. ALWAYS support the vehicle with appro-
priately rated support stands before
using this jack.
2. Only use this jack on hard level sur-
faces such as concrete or asphalt.
3. DO NOT overload this jack beyond the
maximum lifting capacity. Overloading
can cause the jack to collapse.
4. DO NOT use this jack to lift or support a
vehicle.
5. Keep fingers and hands away from
pinch points when lowering.
6. Only transport load with jack platform
in the lowered position.
7. Center the load on the jack for stability
and use safety chain to secure load.
COPYRIGHT © DECEMBER, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#TR8855 PRINTED IN CHINA
Specifications
Maximum Lifting Capacity .................. 1,100 Lbs.
Lifting Range ........................................34"–71
3 ⁄
8
"
Weight ................................................... 138 Lbs.
Assembly
Refer to the parts breakdown on the back of this
page to understand how the jack is assembled.
Operation
Pump Control Handle (Figure 1): Point to the
left to allow the jack platform to lift when pumped.
Point to the right to lower the jack. (If the jack
holds a heavy load, turn very slowly to control the
lowering rate and avoid dropping the load.)
Foot Pedal Pump (Figure 1): When moved up
and down, the foot pedal pump lifts the jack plat-
form.
Figure 1. Pump controls.
Pump
Control
Handle
If you need help with the Model H8088, call our
Technical Support line at: (570) 546-9663.
Figure 2. Platform adjustment knobs.
Platform Adjustment Knobs (Figure 2): Located
under the jack platform, these knobs allow for pre-
cision placement and leveling of the platform.
Pump
Foot
Pedal
Platform
Adjustment Knobs