Grizzly ZX3 - Manual (Page 23)

G1023Z Series Heavy-Duty 10'' Table Saw -21-
Guard Bracket
Figure 13. Attaching the 5 ⁄
8
"-18 blade guard
mounting shaft.
Figure 14. Blade guard mounting bracket
To install the blade guard assembly :
1. Thread the 5 ⁄
8
"-18 blade guard mounting
shaft into the mounting location on the back
of the table saw base as shown in
Figure
13 .
2. Secure the blade guard mounting shaft with
the included
5 ⁄
16
"-18 hex bolt.
3. Slide the loosely assembled bracket onto
the blade guard mounting shaft and tem-
porarily hand tighten the nuts as shown in
Figure 14 .
Motor Brace
A red motor brace has been installed for shipping
purposes. Remove this brace before continuing
with assembly. The bolts that secure the brace
should be screwed back in at the locations from
which they came.
NOTICE
The blade guard mounting bracket (Figure
13) is supplied with the Shop Fox
® Fence.
Blade Guard
Mounting Shaft
Motor Brace
Installed For
Shipping Only!
Blade Guard
Mounting Bracket
Figure 12b. Motor brace.