Grizzly T10050 - Manual (Page 5)

T10050 Right angle iron Bender
-5-
4.. use the handle to bend the workpiece to the
desired angle ( Figure 14).
2.. place the workpiece into the clamp and adjust
the workpiece position as needed. Rotate the
clamp cam shaft to clamp the workpiece
(
Figure 12).
Figure 12.. Clamping workpiece.
Figure 14.. Bending workpiece.
88L
Figure 15.. Releasing workpiece.
—if the clamp die does not move far enough
to fully clamp the workpiece, repeat Steps
1 & 2.
3.. adjust the bending plate to support the work-
piece while bending ( Figure 13).
8L
Figure 13.. Tightening bending plate.
5.. loosen the bending plate and clamp cam
shaft to release the workpiece ( Figure 15).
NOTICE
Use the machine only as it is intended to be
used.. Adding cheater bars or other meth-
ods of increasing leverage may damage the
machine and will void the warranty..