Loading and using the dryer, 32 1 care and cleaning of the dryer, Sorting and loading hints – GE 450 User Manual

Page 9: Fabric care labels, Water temperature, Follow these steps, Wash labels dry labels bleach labels

Advertising
background image

The Exterior: Wipe or dust any spills or washing
compounds with a damp cloth. Dryer control
panel and finishes may be damaged by some
laundry pretreatment soil and stain remover
products. Apply these products away from the
dryer. The fabric may then be washed and dried
normally. Damage to your dryer caused by these
products is not covered by your warranty.

The Lint Filter: Clean the lint filter before each
use. Moisten your fingers and reach into the filter
opening. Run your fingers across the filter. Have a
qualified technician vacuum the lint from the dryer
once a year.

The Exhaust Duct: Inspect and clean the exhaust
ducting at least once a year to prevent clogging.
A partially clogged exhaust can lengthen the
drying time.

Follow these steps:

Turn off electrical supply by disconnecting the
plug from the wall socket.

Disconnect the duct from the dryer.

Vacuum the duct with the hose attachment and
reconnect the duct.

The Exhaust Hood: Check from the outside that the
flaps of the hood move freely when operating. Make
sure that there is no wildlife (birds, insects, etc.)
nesting inside the duct or hood.

3

2

1

Care and Cleaning of the Dryer

9

Consumer Support

Tr

oubleshooting T

ips

Operating Instructions

Safety Instructions

Loading and using the dryer.

Always follow the fabric manufacturer’s care label when laundering.

Sorting and Loading Hints

As a general rule, if clothes are sorted properly for the washer, they are sorted properly for the dryer.
Try also to sort items according to size. For example, do not dry a sheet with socks or other small items.

Do not add fabric softener sheets once the load has become warm. They may cause fabric softener stains.
Bounce

®

Fabric Conditioner Dryer Sheets have been approved for use in all GE Dryers when used in accordance with the

manufacturer’s instructions.

Do not overload. This wastes energy and causes wrinkling.

Do not dry the following items: fiberglass items, woolens, rubber-coated items, plastics, items with plastic trim and
foam-filled items.

Fabric Care Labels

Machine
wash
cycle

Normal

Permanent Press/

wrinkle resistant

Gentle/

delicate

Hand wash

Do not wash

Do not wring

Water
temperature

Hot

(50

°C/120°F)

Warm

(40

°C/105°F)

Cold/cool

(30

°C/85°F)

Tumble
dry

Dry

Normal

Permanent Press/

wrinkle resistant

Gentle/

delicate

Do not tumble dry

Do not dry
(used with

do not wash)

Heat
setting

High

Medium

Low

No heat/air

Special
instructions

Line dry/

hang to dry

Drip dry

Dry flat

In the shade

Bleach
symbols

Any bleach

(when needed)

Only non-chlorine bleach

(when needed)

Do not bleach

Below are fabric care label “symbols” that affect the clothing you will be laundering.

WASH LABELS

DRY LABELS

BLEACH LABELS

Advertising