Grizzly H3114 - Manual (Page 16)

-14- H3114 Router Table
5. Loosen the threaded knobs that secure the
main fence.
6. Place a straightedge across the entire face of
the pocket jointing fence and adjust the main
fence until the outside diameter of the router
bit just touches the straightedge (
Figure 20 ).
Figure 19. Proper setup for jointing an edge.
Figure 20. Use a straightedge to properly adjust
the main fence.
Routing operations on your Model H3114 are
grouped into three main techniques:
• Jointing an edge (Page 14)
• Groove cutting (Page 15)
• Profile cutting with pilot bits (Page 16)
Jointing an edge:
Jointing the edge of a board involves using a
straight cutting router bit to remove wood from the
edge face of a board. The result is a perfectly flat
and square edge used as the glue edge when
gluing multiple boards together to form a larger
panel.
1. Secure a straight cutting router bit into your
router according to the router manufacturer’s
instructions.
2. Snap one of the table inserts into the
recessed hole on the table. Use the insert
with the smallest hole that still allows the bit
free rotation.
3. Raise the bit to a height equal to that of the
thickness of your board.
4. Loosen the threaded knob on the pocket
jointing fence and slide the pocket jointing
fence from the main fence to the desired
depth of cut (
Figure 19 ). Tighten the thread-
ed knob when adjusted correctly. Note–The
face of the pocket jointing fence must be par-
allel to the main fence face before performing
any routing operations.
Operation
7. Tighten the main fence threaded knobs.
8. Double check that the router is secured to the
table. If it is, the router table is ready for use.
Pocket Jointing
Fence
Router Bit
Main Fence
Threaded Knob
Depth Of Cut
Just
Touches
Here
Straightedge Contact
Across Entire Pocket
Jointing Fence Face
Loose hair and clothing
could get caught in
machinery causing seri-
ous personal injury.
Keep loose clothing
rolled up and long hair
tied up and away from
machinery.
Projectiles thrown from
the machine could cause
serious eye injury. Wear
safety glasses during
assembly.