Grizzly G1129 User Manual
Page 14
-12-
G1128/G1129 Power Feeders
Figure 7.
Table Saw Adjustments:
Pinching, binding and blade height are issues of
concern when using the power feeder with a table
saw. If you are
ripping
boards
4" or wider
, place
the power feeder between the fence and blade
with the rollers turned slightly toward the fence. If
you are
ripping
materials
less than 4"
, set the
rollers as close as possible to the fence. Do not
set the rollers so the waste side of your material
binds or pinches the blade. The rollers should be
angled with
no more than
1
⁄
8
"
of variation
between the leading and trailing wheels.
IMPORTANT:
The blade height on your table
saw must just slightly exceed the height of your
workpiece.
Do Not
allow the blade to cut into your
rollers
. Figure 7.
You may elect to remove the middle wheel to
gain even more clearance.
Some fences clamp at the front only. You will
need to use an auxiliary clamp for the back of
your fence if this is the case. The power feeder
will push the fence out of alignment if it is not
clamped adequately.