Grizzly G1013 - Manual (Page 20)

-18- G1013 Combination Sander
For general wood sanding, position and secure
table, turn the machine on, and slowly feed your
workpiece into the belt or disc. For disc sanding,
note the direction of the disc rotation and be sure
to feed your workpiece into the disc’s downward
spin. Also, be sure to keep the work table about
1 ⁄
16
" away from the belt or disc.
Remove platen and move Small Upper Idler
Roller rearward so the workpiece will not be acci-
dentally forced against it. Slowly feed the work-
piece into the belt; the belt will follow the contour
of the workpiece.
See Figure 20.
Figure 20. Contour sanding.
General Sanding Contour Sanding