Grizzly G7297 - Manual (Page 15)

G7297 Disc Sander -13-
Figure 6 . Removing protective layer.
Figure 7. Table aligned with sanding disc.
The table must be aligned to the face of the sand-
ing disc so that the sandpaper does not rub
against the table.
To align the table:
1. Loosen the screws that secure the table to
the table support bracket.
2. Align the table so that there is a 1 ⁄
16
'' gap
between the 12" disc and the table ( Figure
7 ).
3. Tighten the screws loosened in step 1 .
4. Spin the disc by hand to check if the sand-
paper is touching the table. Note—
DO NOT
turn the disc sander on at this point.
5. Repeat steps 1-3 if sandpaper touches table
at any point in the rotation.
3. Position the exposed adhesive on the upper
half of the disc that extends above the table.
Once it is positioned evenly across the disc,
press the adhesive onto the surface.
4. Now rotate the disc so the lower half is now
above the table.
5. Bend the paper back and remove the
remaining half of the protective layer (
Figure
6 ), and then press this portion against the
disc.
Aligning Table
1⁄16 Gap
Table Support
Screws