GE 29869 - Manual (Page 16)

16
Important Instructions for Moving the
Answerer
To move the answerer to a different location in the house, follow these instructions:
1. Disconnect the phone line or any phones you may have connected to the unit.
2. Install a battery, if you have not already done so. This will ensure that your messages are not lost. See
“Installing the Battery”.
3. Go to the electrical outlet and unplug the power supply. DO NOT UNPLUG THE POWER JACK
CONNECTED TO THE UNIT. If you do, all memory will be erased.
4. Move the unit and phone line to the desired location.
5. Plug in the power supply into an electrical outlet.
6. The MESSAGES indicator shows that the messages have not been erased.
7. Connect all necessary phone lines.
General Product Care
To keep your answerer working and looking good, follow these guidelines:
• Avoid putting it near heating appliances and devices that generate electrical noise (for example, motors
or fluorescent lamps).
• DO NOT expose to direct sunlight or moisture.
• Avoid dropping answerer and/or other rough treatment.
• Clean with a soft cloth.
• Never use a strong cleaning agent or abrasive powder because this will damage the finish.
• Retain the original packaging in case you need to ship it at a later date.
Troubleshooting Tips
Doesn’t answer, or answers on 10th ring
• Make sure answering system is turned on.
• Memory is full, erase some messages.
• Check AC (electrical) power and phone line connections.
Incoming messages are incomplete
• Was an extension phone picked up?
• The caller left a message that is longer than the message length you chose during setup.
• Memory is full.
• You accidentally pressed the STOP/SET button when you were playing back your messages.