Garmin G60 - Manual (Page 91)

nüvifone G60 user’s guide 
Appendix
Change the Fuse in the
Vehicle Power Cable
If your device does not charge
in your vehicle, you may need to
replace the fuse located at the tip of
the vehicle power cable. The vehicle
power cable is an optional accessory.
nOTE: When replacing the fuse, do
not lose any of the small pieces and
make sure they are put back in the
proper position.
1. Unscrew the
end piece,
and remove it.
2. Remove the
fuse (glass
and silver
cylinder), and
replace it with a 1A fast blow fuse
of the same size.
3. Ensure that the silver tip is
located in the end piece. Screw
on the end piece.
Mount on Your
Dashboard
Use the enclosed mounting disk to
mount your device to the dashboard
and comply with certain state and
local regulations.
nOTE: The permanent mounting
adhesive is extremely difficult to
remove after it is installed.
1. Clean and dry the dashboard
where you are placing the disk.
2. Remove the backing from the
adhesive on the bottom of the
disk.
3. Place the disk on the dashboard.
4. Remove the clear plastic cover
from the top of the disk.
5. Place the suction cup mount
on top of the disk. Flip the lever
down (toward the disk).
End piece
Silver tip
Fuse
End piece
Silver tip
Fuse