Grizzly G0548Z - Manual (Page 22)

-20-
g0548zp, g1028z2, g1029z2-z2p (mfg. 12/12+)
12. Apply the 6 x 20mm foam strip to the bottom
of the collector, then trim the excess and
evenly match the ends (see
figure 20).
13. Attach a collection bag to the hooks around
the bottom of the collector, then tighten
the collection bag clamp around the foam
strip to hold the bag in place, as shown in
figure 21.
14. insert the inlet connector over the impeller
intake hole, then secure it in place with the
#10 x
3 ⁄
8
" tap screw, as shown in figure 22.
figure 21. Collection bag installed.
Collection
Bag
Bag Clamp
figure 22. inlet connector installed.
x 1
g1028z2/g1029z2/
g1029z2p assembly
to assemble your machine:
1. mount the casters to the base plate using
(16) 5 ⁄
16
"-18 x 1 ⁄
2
" flange bolts, as shown in
figure 23.
figure 23. mounting casters to base.
2. set the collector body on top of the base
plate so the intake portion is near the edge of
the base plate and the bolt holes are aligned,
as shown in
figure 24. secure the collector
body to the base plate with (4) 5 ⁄
16
"-18 x 1 ⁄
2
"
flange bolts.
figure 24. mounting collector to base.
x 4
x 4