Installation/operation, Warning, Caution – Graco Inc. 235457 User Manual

Page 7

Advertising
background image

308-235

7

Installation/Operation

How to Clean the Spray Tip

and Clear a Spray Tip Obstruction.

WARNING

To reduce the risk of fluid injection or splashing in

the eyes or on the skin,

do not hold a hand, body

or rag in front of the spray tip when cleaning or

checking a clogged tip. Point the gun toward the

ground or into a waste container when checking to

see if the spray tip is cleared.

Do not try to “blow back” paint; this is not an air

spray gun.

Do not wipe fluid buildup off the gun or spray tip

until pressure is relieved.

Cleaning during the day.

1. Follow

the Pressure Relief Procedure, page 5.

2. Clean the front of the tip frequently during the day

to help reduce buildup. Also clean the tip and tip

guard at the end of each work day. Use a solvent-

soaked brush to clean the spray tip.

Clearing an obstruction.

If the spray tip clogs while spraying, immediately stop

spraying, then:

Gun 235–458 – with standard tip guard
1. Engage the trigger safety latch, open the pressure

drain valve.

2. Remove the spray tip and blow out the obstruction

by applying air to the front of the spray tip. Or, let

the spray tip and gun nozzle soak to dissolve the

obstruction. If it won’t dissolve, jar it out by tapping

the back of the spray tip against a flat surface.

CAUTION

Never soak the entire gun in solvent. Prolonged

exposure to solvent can ruin the packings.

Gun 235–459 and 237–691– with RAC IV tip guard
1. Engage the trigger safety latch. Rotate the RAC IV

tip handle 180

_

. See Fig. 4.

2. Disengage the trigger safety latch. Trigger the gun

into a pail or onto the ground to remove clog.

3. Engage the trigger safety latch. Rotate the tip

handle to the spraying position.

4. If the tip is still clogged, lock the gun trigger safety,

shut off the sprayer and disconnect the power

source, and open the pressure drain valve to

relieve pressure. Clean the spray tip as shown in

manual 308–644, supplied with the RAC IV.

Fig. 4

KEY

A

Handle shown in

spraying position. Turn

handle 180_ and

trigger gun to clear

clog.

A

Advertising
This manual is related to the following products: