Surface units & drip pans, Care and cleaning of the range – GE 164D3333P184 User Manual

Page 11

Advertising
background image

Safety Instructions

Operating Instructions

Care and Cleaning

Installation Instructions

Troubleshooting T

ips

Customer Service

Care and cleaning of the range.

Be sure electrical power is off and all surfaces are cool before cleaning any part of the range.

Proper care and cleaning are important so your range will give you efficient and satisfactory service. Follow these
directions carefully in caring for your range to assure safe and proper maintenance.

Oven Shelves

Clean the shelves with an abrasive

cleanser or steel wool.

After cleaning, rinse the shelves with

clean water and dry with a clean cloth.

Surface Units and Drip Pans

To clean the surface units, turn the

control to the highest setting for a

minute. The coils will burn off any soil.

To remove a surface unit:

To remove the drip pans for cleaning,

the surface units must be removed first.
Lift the surface unit about 1 inch above

the drip pan and pull it out.
Do not lift the surface unit more than 1 inch. If
you do, it may not lie flat on the drip pan when
you plug it back in.

NOTE:

Repeated lifting of the surface unit

more than 1 inch above the drip pan can

permanently damage the receptacle.

To replace a surface unit:

Replace the drip pan into the recess in

the cooktop. Make sure the opening in

the pan lines up with the receptacle.
Insert the terminals of the surface unit

through the opening in the drip pan and

into the receptacle.
Guide the surface unit into place so it

rests evenly.

To clean the drip pans:

Drip pans can be cleaned in the

dishwasher or by hand. If you use a

scouring pad, rub lightly to prevent

scratching.

Can I cover the drip pans with foil?

No, because using foil so close to the

receptacle could cause shock, fire or

damage to the range.

CAUTION:

Do not immerse the surface units in

liquids of any kind.

Do not clean the surface units in a

dishwasher.

Do not bend the surface unit plug

terminals.

Do not attempt to clean, adjust or in

any way repair the plug-in receptacle.

To remove the surface unit, lift it
about 1 inch above the drip pan
and pull it out.

Replace the drip pan into the
recess in the cooktop.

If your range is removed for cleaning, servicing or any reason, be sure the anti-tip
device is re-engaged properly when the range is replaced. Failure to take this
precaution could result in tipping of the range and cause injury.

Porcelain Enamel Cooktop

The porcelain enamel finish is sturdy but

breakable if misused. This finish is acid-

resistant. However, any acidic foods

spilled (such as fruit juices, tomato or

vinegar) should not be permitted to

remain on the finish.

Surface unit

Receptacle

Drip pan

11

Advertising