Grizzly H7666 - Manual (Page 10)

Model H7666/H7667 LVLP Spray Gun -10 -
1. Fluid Control: Controls the volume of
material that travels through the fluid
tip.
2. Pattern Control: Adjusts the spray
pattern from a round pattern to a wide
fan.
3. Air Flow Control: Controls the fluid
pressure inside the spray gun (H7667
only).
4. Atomizing Cap: Controls the spray
pattern from vertical to horizontal.
5. Trigger: Two stage trigger. Stage
one only releases compressed air for
blowing off the work piece. Stage two
sprays material.
6. Cup: 600ml plastic cup allows easy
viewing of material level. Includes a
vented cap.
Figure 3. Installing filter.
Figure 4. Controls.
2. Screw the cup onto the top of the
body.
3. Attach the air hose to the spray gun
with a 1 ⁄
4
" NPS quick connect set-up
(not included).
4. Attach the spray gun to an air hose
regulated between 29 and 50 PSI.
Note: For the best results, use a hose
that will be dedicated for spray use
only. Do not use a hose that has been
used with an in-line oiler or other pos-
sible contaminant.
If you need additional help with this assem-
bly, call our Technical Support at: (570)
546-9663.
1. Insert the filter into the gun body (see
Figure 3).
Cup
Fluid Control
Pattern Control
Atomizing Cap
Trigger
Assembly Controls
Air Flow Control