Grizzly STILE AND RAIL SETS C1393-96 - Manual (Page 2)

-2-
The process for completing your rail end cuts is
roughly the same as those for your stile and rail
cuts. The main concern is ensuring that the amount
of reveal at the front edge of your rail matches the
cuts made in your stiles.
To complete your end rail cuts:
1. Adjust your router and
bit, as described
earlier,
and
make
a test
cut
with
the sur-
plus mate-
rial.
2. Join the test cut with your previous cuts and
check the joint to determine flushness.
3. Re-adjust and re-test until you are satisfied with
your results.
4. When satisfied with the results tighten the router
and cut your project material.
A ball bearing is supplied with these router bits
which allow the use of templates for curved work
as seen to the right.
Using a template:
1. The tem-
plate
should
be the
same
size as
the
expected
finished
panel.
2. The curved portion of the workpiece should
be rough cut so that no more than 1 ⁄
8
" pro-
trudes beyond the template.
3. The fence and miter must be removed when
using a template. A starting pin or block must
be installed as shown in
Figure 2.
Always disconnect power to
the machine when setting up
or making adjustments.
Failure to do this may result
in serious personal injury.
FENCE
Figure 2 . Start block for template cutting.