GE Magnetic Swipe Card Reader TS0861 - Manual (Page 5)

Testing Note — LED operation is configurable via the TS0862 Smart
Door Controller. Refer to the TS0862 Smart Door Controller
Installation & Programming Guide
for details.
The following process checks a typical installation of a
TS0861 Magnetic Swipe Card Reader interfacing with a
TS0862 Smart Door Controller.
Check for correct operation:
1. Set the door to the ‘Access’ state and check that the
Green LED (LED 1) is illuminated.
2. Swipe a suitable Magnetic Swipe Card through the
TS0861. The Green LED flashes.
3. Set the door to the ‘Secure’ state and check that the
Red LED (LED 2) is illuminated.
4. Swipe a suitable Magnetic Swipe Card through the
TS0861. The Green LED flashes.
TS0861 Magnetic Swipe Card Reader Installation Guide 5