Grizzly H8239 - Manual

For questions or help with this product contact Tech Support at (570) 546-9663 or [email protected]
MODEL H8239
SAFETY LOCKING ON/OFF
SWITCH
INSTRUCTIONS
Copyright © ApriL, 2011 By grizzLy industriAL, inC.
WARNING: NO pORTION OF THIS INSTRUCTION SHEET MAY bE REpRODUCED IN ANY SHApE
OR FORM WITHOUT THE WRITTEN AppROvAL OF GRIzzLY INDUSTRIAL, INC.
#ts13931 printed in ChinA
Introduction
the Model h8239 features a large on/oFF pad-
dle with a removable safety key that can be used
to disable the switch. this switch is designed to fit
into
7 ⁄
8
" x 1 5 ⁄
8
" rectangular hole or mounted over a
1 1 ⁄
8
" x 2 1 ⁄
4
" rectangular hole with four #5 screws.
Specifications
rated horsepower ........................................ 2hp
rated Voltage ..................................... 125V/250V
rated Current Amperage ..............................20A
Figure 1. h8239 safety paddle switch.
safety
Key
To reduce risk of serious burns, electrocu-
tion or death when installing this switch:
• Only use this switch to replace an existing
machine switch that has the same physi-
cal configuration and equivalent electrical
specifications/ratings.
• Installation must only be performed by an
electrician or qualified service personnel,
and all applicable electrical codes must
be adhered to.
• Turn off and completely disconnect all
power sources to the machine before
installing the switch.
• Do not use this switch in wet or damp
locations, or near explosive fumes or
flammable liquids. It is not sealed or rated
for these environments.
• Make sure there is a verified machine
ground on the circuit this switch is
installed.