GE 10 DCA - Manual (Page 12)

Consumer Support
Troubleshooting T
ips
Installation Instructions
Care and Cleaning
Operating Instructions
Safety Instructions
12
Installing a J-Model in an existing wall case.
Read these instructions completely and carefully.
Install the Air Conditioner in the Case.
Remove the locking plate on the front
left side.
Remove the shipping pad inside the air
conditioner next to the compressor.
Carefully slide the air conditioner back into
the case. Make sure that the tubing on the
unit does not touch the wall case and that the
case installation is secure.
Reinstall the locking plate with the tab
behind the wall case flange. Tighten
the screw.
Attach the power cord to the base pan
with the clamp.
When the wall outlet is to the left, extend the
cord under the unit and hold it in place with
the clamp.
Attach the front grille. An opening for
the power cord is on the bottom of the
front grille.
G
F
E
D
C
REMOVE SHIP PAD! REMOVE TAPE ON VENT LEVER!
B
A
Locking
plate
Remove
shipping pad
Clamp
Power cord
Power cord
Clamp
Base pan
Remove
screw