Genie INTELLIG 3024 - Manual (Page 22)

©2010 The Genie Company 01/27/2010
22
ADJUSTMENT GUIDE -
SPEED SETTINGS FOR HELP-1.800.354.3643 OR WWW.GENIECOMPANY.COM
Speed settings are pre-programmed at the factory
for the maximum speed. Speed settings should not
need adjustment with this unit.
However, travel speed for the opener can be
adjusted to slower speeds to minimize normal wear
for heavy sectional doors.
NOTE: One piece doors are automatically set during
Limits programming to the slowest speed and
opener speed cannot be reset for one piece doors.
CHANGE SPEED SETTING
Use this guide to ADJUST power head SPEED settings.
There are three (3) Speed settings available on this
unit. Door type (one piece or sectional), door weight
and balance, and condition of door components /
track affect door speed. Speed adjustment may not
be available for some installations depending on
these factors.
1. Press
PROGRAM
SET
on the power head and hold till both
lights turn steady ON. Release button.
Lights go out and Round BLUE light comes ON.
2. Press two times and the Round BLUE and Long
BLUE lights come ON.
3. Press
PROGRAM
SET
once to enter the Speed Programming
menu. The current Speed setting will display on
the LEDs. See table below.
4. Press to raise or to lower UP Speed settings
within the available range.
NOTE: Faster door speeds may not be available.
5. Press
PROGRAM
SET
to set UP Speed level.
6. Press to raise or to lower DOWN Speed
settings within the available range.
NOTE: Faster door speeds may not be available.
7. Press
PROGRAM
SET
to set DOWN Speed level and to exit
Speed menu. Both LEDs flash BLUE to confirm.
Speed Level
Power Head LEDs
Round LED Long LED
Default LED display is the current Speed setting
LED Speed indicator colors
Red Red
Purple Purple
Blue Blue
Speed Level LED indicator colors
MAXIMUM
Red
ON
Red
ON
MID
Purple
ON
Purple
ON
SLOW
Blue
ON
Blue
ON