GE PTDS650EMWT - Manual (Page 6)

Message Displayed Description
(On some models) The message “PAUSE” will scroll
across the display when the dryer’s cycle is paused.
The cycle may be restarted by pressing the START
button.
The message “door” will be displayed when the door
is opened during the dryer’s cycle.
The message “HEAt” will be displayed when the start
button is pressed for a steam refresh or de-wrinkle
cycle. Turn the temperature knob to “High” and press
the start button.
Temperature
HIGH For regular to heavy cottons.
nOTE: STEAM DEWRInklE and STEAM REfRESh require the High temperature setting.
MEDIUM For synthetics, blends, delicates and items labeled permanent press.
LOW For delicates, synthetics and items labeled tumble dry low.
EXTRA LOW For delicates, synthetics and items labeled tumble dry low.
NO HEAT For fluffing items without heat. For use only with the TIMED DRy cycles.
b
Dryness— Selection only used for SEnSOR cycles. Timed Cycles run for the selected time at the selected temperatures.
MORE DRY Use for heavy-duty fabrics.
DRY Use for a normal dryness level suitable for most loads. This is the preferred cycle for energy savings.
LESS DRY Use for lighter fabrics.
DAMP For leaving items partially damp.
C
Estimated Time Remaining Display
• Displays the approximate time remaining until the end of the cycle.
• If the estimated time remaining is 60 minutes or more, “1H” will flash in the display, followed by the additional
remaining minutes. When the time remaining is less than 60 minutes, the timer will count down.
D
About the control settings.
6
A
End of Cycle Signal
This signal will sound just before the end of the cycle to remind you to remove the clothes.
If you select the EXTEnDED TuMblE option, the signal will sound at the end of the drying time and will sound
several times during the EXTEnDED TuMblE cycle. This will remind you that it is time to remove the clothes.
nOTE:
• Remove garments promptly at the sound of signal. Place clothes on hangers so wrinkles won’t set in.
• Use the EnD Of CyClE SIGnAl especially when drying fabrics like polyester knits and permanent press.
These fabrics should be removed so wrinkles won’t set in.
Extended Tumble
Use this option to minimize the wrinkles in clothes. It provides approximately 1 hour of no-heat tumbling after
the clothes are dry.
If you are using CyClE SIGnAl and you select the EXTEnDED TuMblE option, a signal will sound at the end
of the drying time and several times during the EXTEnDED TuMblE cycle. This will remind you that it is time
to remove the clothes.